FAQs

A: Smooth, non-porous surfaces like glass, metal, plastic, and sealed wood are ideal. Avoid rough or textured surfaces as they can prevent the vinyl from adhering properly.

A: Clean the surface thoroughly with the supplied Purell Hand Sanitizing wipe with alcohol formula to remove any dirt, dust, grease, or residue. Ensure the surface is completely dry before applying the label.

A: You'll need a supplied Vinyl Squeegee and possibly a craft knife or pin for dealing with air bubbles.

A: Use the "hinge method." First, peel back a small portion of the backing paper and align the label. Then, use a squeegee to apply the exposed section. Slowly peel back the remaining backing paper while continuing to squeegee the label onto the surface, working from the center outwards to avoid trapping air.

A: The hinge method involves using a piece of supplied tape to create a "hinge" on one side of the label. This allows you to precisely position the label before applying it. After positioning, you can lift the unapplied side, remove the backing, and squeegee the label down from the hinged side.

A: For small air bubbles, you can use a pin or craft knife to gently puncture the bubble and then smooth the vinyl down with your finger or a squeegee.

A: Apply labels in a temperature range of 60°F to 80°F (15°C to 27°C) for best results. Avoid applying labels in direct sunlight or extreme temperatures.

A: Allow the adhesive to cure for at least 24-48 hours before exposing the label to moisture or heavy use. This allows the adhesive to fully bond with the surface.

A: Use a heat gun or hairdryer to gently warm the vinyl, which will soften the adhesive. Then, slowly peel the label away from the surface, working at a shallow angle. If any adhesive residue remains, you can remove it with adhesive remover or isopropyl alcohol.